Removal & Installation
Disconnect negative battery cable. Remove driver's door trim panel. Remove speaker from driver's door and disconnect speaker wiring connector. Remove keypad retaining clip. Disconnect keypad wiring harness and remove keypad. To install, reverse removal procedure.
Disconnect negative battery cable. Remove left-side quarter trim panel. Disconnect electrical connectors and antenna. Remove attaching bolts and module. To install, reverse removal procedure.
Antenna is part of harness and cannot be removed. If damaged or faulty, disconnect antenna connector from RAP module. Secure connector aside. Connect new antenna to RAP module. Using plastic tape, complete installation by securing antenna along path followed by original antenna.
