Removal & Installation (Front & Rear)
Open window fully. Remove door panel. Remove door armrest bracket. Remove protective cover. Remove 4 bolts and access cover (front door only). Remove 2 glass retaining bolts from bottom of door and lift glass out of door. To install, reverse removal procedure.
Disconnect negative battery cable. Remove door glass. See DOOR GLASS under REMOVAL & INSTALLATION. Unplug motor harness connector. Remove fasteners securing regulator. Remove regulator through large opening in door. To install, reverse removal procedure.
Removal & Installation (Front)
Disconnect negative battery cable. Remove door trim panel. Squeeze tabs to remove power window switch housing. Disconnect switch connector. Remove 2 screws and power window switch. To install, reverse removal procedure.
