Steering System: Adjustments Ford Escape II

Steering Wheel Position Sensor Calibration

1. Place the vehicle on a flat level surface with the transmission in PARK. NOTE: Make sure that the steering wheel is turned from right to left before centering or sensor calibration will fail.
2. Rotate the steering wheel from right to left, center the steering wheel and remove hands from the wheel.
3. Connect the scan tool to the vehicle.
4. Turn the ignition key to the RUN position.
5. Using the scan tool, select steering wheel position sensor calibration and follow the scan tool instructions.
6. Clear any PSCM DTCs.
7. Turn the ignition key to the OFF position.
8. Road test the vehicle. If the steering wheel is not in the straight ahead position while driving on a flat road surface, check and adjust the alignment as necessary. Refer to «SUSPENSION SYSTEM-GENERAL INFORMATION»(ref-344068) .