Multifunction Electronic Modules: Removal & Installation Ford Escape I facelift 2

Removal

Note. Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.

Note. Prior to the replacement of the module, it is necessary to upload the module configuration information to a scan tool. This information must be downloaded into the new Smart Junction Box (SJB) after installation. For additional information, refer to MODULE CONFIGURATION . In the event that As-Built data is required (SJB will not communicate), all Remote Keyless Entry (RKE) devices must be programmed to the new SJB. A minimum of 2 RKE devices are necessary to complete the configuration and turn off the flashing interior lights. The Tire Pressure Monitoring System (TPMS) functionality is integral to the SJB.

Note. The steps included in the SJB removal and installation procedure are critical to restoring the vehicle security and tire pressure monitoring systems to normal operation. A new SJB is delivered in a manufacturing mode with 7 pre-set DTCs related to the TPMS. To clear the DTCs, successful configuration of the SJB must occur, followed by successful TPMS sensor training, and a successful self-test. The DTCs are as follows: B106D (Tire Pressure Monitor System [TPMS] Initiators Not Configured) B2477 (Module Configuration Failure) B2868 (Left Front Tire Pressure Sensor Fault) B2869 (Right Front Tire Pressure Sensor Fault) B2870 (Right Rear Tire Pressure Sensor Fault) B2871 (Left Rear Tire Pressure Sensor Fault) C2780 (ECU in Manufacturer Sub-State)

1. Upload the module configuration information from the SJB. For additional information, refer to «MODULE CONFIGURATION»(ref-344078) .
2. Remove the transmission selector lever bezel from the floor console finish panel.
3. Remove the floor console SJB cover.
4. Remove the floor console finish panel.
5. Disconnect the 7 electrical connectors.
6. Remove the 2 bolts and the SJB.

Installation

1. Install the SJB. Install the 2 bolts. Connect the 7 electrical connectors.
2. Install the transmission selector lever bezel into the floor console finish panel.
3. Install the floor console SJB cover.
4. Download the SJB configuration information from the scan tool. For additional information, refer to «MODULE CONFIGURATION»(ref-344078) .
5. Train the tire pressure sensors. For additional information, refer to «WHEELS & TIRES»(ref-344055) .
6. Carry out the SJB self-test (must include an on-demand self-test) and then repeat the self-test to confirm all DTCs have been cleared.
7. Rotate the instrument panel dimmer switch from the full dim position to the dome ON position. This will make sure that all displays are visible under all lighting conditions.