Charging System - Generator & Regulator: Removal & Installation Ford Edge I

REMOVAL AND INSTALLATION

1. Disconnect the battery. For additional information, refer to «BATTERY, MOUNTING AND CABLES»(ref-292545) article.
2. Remove the cooling fan. For additional information, refer to «ENGINE COOLING»(ref-292560) article.
3. Rotate the accessory drive belt tensioner counterclockwise and position the accessory drive belt aside.
4. Position the generator B+ terminal protective cover aside, remove the nut and position the generator B+ terminal aside. To install, tighten to 12 Nm (9 lb-ft).
5. Disconnect the generator electrical connector. Detach the pin-type retainer and wiring harness.
6. Remove the generator stud nut. To install, tighten to 47 Nm (35 lb-ft).
7. Remove the generator stud. To install, tighten to 8 Nm (71 lb-in).
8. Remove the RH fender splash shield. For additional information, refer to «FRONT END BODY PANELS»(ref-292537) article.
9. Loosen the generator bolt and remove the generator. To install, tighten to 47 Nm (35 lb-ft).
10. To install, reverse the removal procedure.