Selector Lever Cable Adjustment
- Disconnect the selector lever cable end from the manual control lever.
- Place the manual control lever in DRIVE. Rotate the manual control lever clockwise until it stops. Rotate the manual control lever counterclockwise one detent.
- Place the selector lever in DRIVE.
- Unlock the adjuster. Pry the latch up. Push the lock tab to slide it over.
- Slide the selector lever cable end forward or backward to align it with the manual control lever.
- With the adjuster locking tab released, connect the selector lever cable end to the manual control lever.
- Slide the release tab back to lock the adjuster.
- Verify that the vehicle starts in PARK and NEUTRAL only and that the reverse lamps illuminate in REVERSE.
Scheme 4
Scheme 4: Selector Lever Cable
| Item | Part Number | Description |
|---|
| 1 | 14A464 | Mass air flow (MAF) sensor electrical connector |
| 2 | 6758 | Engine vent tube |
| 3 | N606678 | Air cleaner assembly bolt |
| 4 | 9C632 | Air cleaner outlet tube clamp |
| 5 | 9C662 | Air cleaner assembly |
| 6 | 7E395 | Selector lever cable |
| 7 | W500213 | Selector lever cable bracket bolts |
| 8 | 7B229 | Selector lever cable bracket |
| 9 | 78061A16 | Selector lever trim ring (MKX only) |
| 10 | 78045A76 | Center console trim cover |
| 11 | 78045A06 | Center console side cover |
| 12 | W706092 | Power outlet trim cover fasteners |
| 13 | 78047A04 | Power outlet trim cover |
| 14 | 7K004 | Selector lever assembly |
| 15 | W707142 | Selector lever cable floor grommet nuts |
| 16 | 57809 | Selector lever cable floor grommet |
