REMOVAL & INSTALLATION
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery. |
Disconnect negative battery cable. Remove seat assembly. See SEAT ASSEMBLY . Disconnect seat motor harness connectors. Release harness retainers from adjusters/motors assembly. Remove 4 screws attaching adjusters/motors assembly to seat. Remove adjusters/motors as an assembly. To install, reverse removal procedure.
Disconnect negative battery cable. Remove recliner lever retaining screw and remove lever. Remove 3 screws holding switch and bezel to seat. Pull switch and bezel away from seat enough to disconnect power seat switch harness connector. Disconnect power seat switch harness connector. Remove 2 screws holding switch to bezel. Remove switch from bezel. To install, reverse removal procedure.
Remove 4 bolts/nuts attaching seat frame to floor pan. Remove 2 bolts holding power seat to center seat section. Disconnect power seat wiring harness connector located under seat. Remove seat from vehicle. To install, reverse removal procedure. Tighten seat mounting screws to 21 ft. lbs. (29 N.m).
