Starting - Service Information: Overview Dodge Charger VI

IDENTIFICATION THAT REMOTE START IS ACTIVATED

To identify that Remote Start has been activated the following will occur

1. Horn will sound and lights will flash to acknowledge a start command was received.
2. Park Lamps will turn on to indicate that the engine is running in remote start mode.

OPERATION

The remote start antenna is located on the roof structure rib above the rear windshield. The antenna interfaces with the Radio Frequency (RF Hub) module through a coaxial electrical cable and electrical connector. The antenna helps to amplify the signal for the Remote Keyless Entry (RKE) key FOBIK.

Scheme 2

1. Disconnect the negative battery cable.
2. Remove the headliner. Refer to «HEADLINER, REMOVAL»(ref-481397-S14889474212012062200000) .
3. Disconnect the remote start antenna (1) from the RF Hub module jump wire (2) located on the driver side D-pillar.
4. Remove the remote start harness (3) from the D-pillar.
5. Gently pull down on the antenna mounting bracket to remove from the structural support rib.
6. Remove the remote start antenna from the mounting bracket.