INSTALLATION
- Snap the left side of the Integrated Power Module (IPM) housing in its mounting bracket and connect the various electrical connectors. NOTE: Ensure that the Connector Positive Assurance (CPA) on the five-pin B+ connector is positively engaged to prevent generating a Diagnostic Trouble Code (DTC).
- Rotate the IPM clockwise until secured in mounting bracket. An audible click may be heard.
- Install the battery «(Refer to ELECTRICAL/BATTERY SYSTEM/BATTERY - INSTALLATION)»(ref-248889-S17951773902007022700000) .
- Install the battery thermal guard.
- Connect the negative and positive battery cables.
- Using a scan tool, check for any stored diagnostic trouble codes. Ensure that all vehicle options are operational.
- Position the mounting ring on the instrument panel and feed the wires through the ring. Index the cap and the mounting ring with the index tab at the 9 o'clock position to the key in the instrument panel. Install the ring.
- Connect the wires to the base. Orientate the base alignment rib at the 11 o'clock position to mate the groove in the mounting ring to the base.
- Push the base into the bezel until it locks in place.
- Check operation of outlet or element and install the outlet cap.