BATTERY SPECIFICATIONS
| Application & Group | Cold Cranking Amps | Amp Hr. Rating |
|---|
| 2.4L (Group 34) | 600 | 66 |
FLUID CAPACITIES
| Application | (1) Quantity |
|---|
| Automatic Transaxle (Mopar ATF Plus Type 7176) |
| 3-Speed |
| Drain & Refill | 4.0 Qts. (3.8L) |
| Dry Refill | 8.5 Qts. (8.0L) |
| 4-Speed |
| Drain & Refill | 4.0 Qts. (3.8L) |
| Dry Refill | 9.1 Qts. (8.6L) |
| Cooling System (2) | 11.2 Qts. (10.6L) |
| Crankcase (Includes Filter) (3) | 4.5 Qts. (4.3L) |
| Power Steering Fluid (4) | 1.7 Pts. (.8L) |
| (1) Approximate quantity listed. (2) Quantity includes heater and coolant recovery tank. Add 2 qts.(1.9L) if equipped with rear heater. (3) Use engine oil with API SH or SH/CD rating. (4) Use only Mopar power steering fluid. DO NOT use automatic transmission fluid. |
| (1) | Approximate quantity listed. |
| (2) | Quantity includes heater and coolant recovery tank. Add 2 qts.(1.9L) if equipped with rear heater. |
| (3) | Use engine oil with API SH or SH/CD rating. |
| (4) | Use only Mopar power steering fluid. DO NOT use automatic transmission fluid. |
SPARK PLUG SPECIFICATIONS
| Application | Gap In. (mm) | Torque Ft. Lbs. (N.m) |
|---|
| 2.4L | .048-.053 (1.22-1.35) | 20 (27) |
| (1) Check plug gap specification on underhood vehicle emission control label. If spec differs from that listed above, use specification on underhood vehicle emission control label. |
| (1) | Check plug gap specification on underhood vehicle emission control label. If spec differs from that listed above, use specification on underhood vehicle emission control label. |
SPARK PLUG SPECIFICATIONS (1)
Firing Order. Scheme 1
THROTTLE POSITION SENSOR VOLTAGE SPECIFICATIONS
| Throttle Opening | (1) (2) Volts |
|---|
| At Idle | Greater Than .40 |
| At Full Throttle | Less Than 3.80 |
| (1) Measure voltage at center terminal on throttle position sensor with ignition on. (2) Voltage should increase smoothly when moving throttle from idle to full throttle. |
| (1) | Measure voltage at center terminal on throttle position sensor with ignition on. |
| (2) | Voltage should increase smoothly when moving throttle from idle to full throttle. |
THROTTLE POSITION SENSOR VOLTAGE SPECIFICATIONS
