Home/Dodge/Caravan/Dodge Caravan III (1995-2000)/Repair manual/Cooling System (Mechanical)/Engine Cooling System Specifications: Other

Contents

Wiring diagrams Section: Cooling System (Mechanical)

All sections

Engine Cooling System Specifications: Other Dodge Caravan III

Cooling System (Mechanical) ~123 words

2.5L

Remove vent plug from top of thermostat housing. Fill cooling system, and allow air to bleed from cooling system. Install vent plug once coolant reaches thermostat housing level. Tighten vent plug to 15 ft. lbs. (20 N.m).

3.3 & 3.8L

Remove engine temperature sending unit. Engine temperature sending unit is located in front of cylinder head, near thermostat housing, just below spark plug wire holder.
Fill cooling system until coolant comes out of temperature sending unit mounting hole. Tighten sending unit to 60 INCH lbs. (7 N.m). Finish filling cooling system.

5.9L Diesel

For bleeding procedures see the 5.9L V8 TURBO DIESEL - VIN [D] article in ENGINES section. DO NOT operate engine while filling cooling system.