REMOVAL & INSTALLATION
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery. |
Lower window to full down position, if possible. Remove screws attaching trim panel to door. Remove window switch. Using trim tool, disconnect clips around edge of door. Lift panel up and outward to release retainers. Disconnect door handle linkage and all wiring. Remove trim panel. To install, reverse removal procedure.
Note. Power window motor is integral to window regulator unit. If power window motor is faulty, entire window regulator must be replaced.
Remove door trim panel. See DOOR TRIM PANEL. Remove watershield. Remove nuts attaching window to regulator. Remove window from door or tape window in raised position. Disconnect power window motor connector. Remove regulator screws. (Scheme 1) Remove window motor and regulator as an assembly. To install, reverse removal procedure.
Scheme 1
Disconnect negative battery cable. Using a trim stick, gently pry upper edge of switch bezel to release retainer securing bezel to door trim panel. Pull switch and bezel away from door trim panel and disconnect switch wire connector. To install, reverse removal procedure.
