WarningAll of the stripped surfaces must be protected by means of the approved electrolytic rezincing process reference C8
WarningObserve the elementary rules of hygiene and safety (wear a face mask to protect against fumes and vapour - work in a well ventilated space)
Recommended tools
Fitting gauge
Additional operations
Disconnect the battery negative terminal
Removing - refitting
- Wing
- Bumper
- Radiator
- Fans
- Condenser
- Headlamp
Detach
- Pipes
- Electrical harnesses
Replacement Parts
(1) front panel support
Preparation of the replacement parts
Preparation of the mating edges and protection with a weldable primer
Separating
Figure 1
Remove the spot welds using an 8 mm drill
Remove the front half-panel and the front panel support
Bodywork cleaning and preparation
Figure 2
Preparation of the mating edges and protection with a weldable primer
Welding
Fit the front panel support
Check the positioning with the fitting gauge
Weld with electric spot welds (see figure 1)
Weld with MAG plug welds (see figure 1)
Sealing - protection
Refer to the corresponding procedure
Reinitialisation
Reconnect the battery
WarningPerform the operations to be carried out following reconnection of the battery (see the relevant operation)