Power Windows: Other Chrysler Pacifica CS

WINDOW SWITCH

The Driver Door Module (DDM) or Passenger Door Module (PDM) control the battery and ground feeds to the power window motors. The driver and front passenger door power window switches are integral to the DDM or PDM. The rear passenger switches are inputs to the DDM or PDM. When the power window lockout switch is depressed it will toggle between window lockout enabled (illuminated red) and window lockout disabled (illuminated emerald green). When the window lockout is enabled, the switch illuminates red and extinguishes the illumination in the passenger window lift switches indicating that they are disabled and will not activate their corresponding window. When window lockout is enabled the DDM will still be able to actuate all of the windows. When the window lockout is disabled, the window lockout switch will illuminate emerald green and again allow the passenger window lift switches to activate their corresponding window and return illumination to the passenger window switches.

WINDOW MOTOR

Window motors use permanent type magnets. The B+ and ground applied at the motor terminal pins will cause the motor to rotate in one direction. Reversing current through the motor terminals will cause the motor to rotate in the opposite direction.

Any diagnosis of the power window system should begin with the use of the DRB III(R) diagnostic tool. For information on the use of the DRB III(R), refer to BODY DIAGNOSTIC PROCEDURES .

For complete circuit diagrams, refer to SYSTEM WIRING DIAGRAMS .

FRONT DOOR

Note. Secure window in the UP position before removing motor.

1. Disconnect and isolate the battery negative cable.
2. Remove the front door trim panel «(Refer to BODY/DOOR - FRONT/TRIM PANEL - REMOVAL)»(ref-245423-S16680146352006110200000) .
3. Remove the front door speaker «(Refer to ELECTRICAL/AUDIO/SPEAKER - REMOVAL)»(ref-245447-S29942397042006110200000) .
4. Remove the watershield.
5. Disconnect electrical harness wire connector from the motor.
6. Remove mounting fasteners and motor.

REAR DOOR

Note. Secure window in the UP position before removing motor.

1. Disconnect and isolate the battery negative cable.
2. Remove the rear door trim panel «(Refer to BODY/DOORS - REAR/TRIM PANEL - REMOVAL)»(ref-245423-S10651588582006110200000) .
3. Remove the rear door speaker «(Refer to ELECTRICAL/AUDIO/SPEAKER - REMOVAL)»(ref-245447-S29942397042006110200000) .
4. Remove the watershield.
5. Disconnect electrical harness wire connector from the motor.
6. Loosen window regulator mounting fasteners (do not remove).
7. Remove mounting fasteners and motor.

1. Install motor and mounting fasteners to regulator.
2. Connect electrical harness connector.
3. Install front door trim panel «(Refer to BODY/DOOR - FRONT/TRIM PANEL - INSTALLATION)»(ref-245423-S26865939162006110200000) .
4. Connect battery negative cable.

1. Install motor and mounting fasteners to regulator.
2. Install window regulator «(Refer to BODY/DOORS - REAR/WINDOW REGULATOR - INSTALLATION)»(ref-245423-S42665719012006110200000) .
3. Connect electrical harness connector.
4. Install rear door trim panel «(Refer to BODY/DOORS - REAR/TRIM PANEL - INSTALLATION)»(ref-245423-S19646409282006110200000) .
5. Connect battery negative cable.