Home ReviewsRefund
Home/Chrysler/Pacifica/Chrysler Pacifica CS (2003-2008)/Repair manual/Accessories Control Systems/Electronic Control Modules: Removal & Installation
Contents Wiring diagrams Section: Accessories Control Systems All sections

Electronic Control Modules: Removal & Installation Chrysler Pacifica CS

Accessories Control Systems ~283 words

INSTALLATION

  1. Place the BCM onto the mounting bracket.
  2. Install the four screws holding the BCM to the bulkhead. (Схема №2)
  3. Connect the five wire connectors to the BCM.
  4. Attach the 72-way bulkhead connector onto the Body Control Module (BCM) mounting assembly.
  5. Install the knee blocker airbag «(Refer to ELECTRICAL/RESTRAINTS/KNEE BLOCKER AIRBAG - INSTALLATION)»(ref-245421-S08151036822006110200000).
  6. Install the lower instrument panel silencer.
  7. Verify vehicle and system operation.

REMOVAL

  1. Disconnect and isolate the battery negative cable.
  2. Remove the trim panel from the front door «(Refer to BODY/DOOR - FRONT/TRIM PANEL - REMOVAL)»(ref-245423-S16680146352006110200000) .
  3. Remove the mounting fasteners.
  4. Remove the door module from the front door trim panel.
  1. Position the door module onto the front door trim panel.
  2. Install the door module to the back of the front door trim panel. Tighten the screws to 2.2 N.m (20 in. lbs.).
  3. Install the trim panel onto the front door «(Refer to BODY/DOOR - FRONT/TRIM PANEL - INSTALLATION)»(ref-245423-S26865939162006110200000) .
  4. Connect the battery negative cable.
  1. Install the PCM.
  2. Install the 3 mounting screws. (Схема №19)
  3. Tighten screws.
  4. Install and lock the 4 electrical connectors. (Схема №20)
  5. Install the left front splash shield.
  6. Install the left front wheel.
  7. Lower vehicle.
  8. Connect the negative battery cable.
  1. Position the drivers seat as far upward and rearward as possible.
  2. Open hood, disconnect and isolate the negative battery cable.
  3. Remove the memory heated seat adjustable pedal module attaching screws.
  4. Disconnect the module electrical connectors.
  5. Remove the module from under drivers seat.
  1. Position the memory heated seat adjustable pedal module under the drivers seat.
  2. Connect the module electrical connectors.
  3. Install the module attaching screws.
  4. Connect the negative battery cable.
  5. Position the drivers seat in its original position.
  6. Verify correct system operation.

More articles — Electronic Control Modules