SHAFT SEAL
Note. It is not necessary to replace shaft seal because of a small amount of oil found on adjacent surfaces. A small amount of oil is normal for lubrication purposes. Shaft seal should only be replaced after a confirmed refrigerant leak is found.
Note. Shaft seal replacement procedure is for 10PA17C compressor. Shaft seal replacement procedure for 10PA17 compressor is not available.
Ford Motor Co. (Taurus 3.4L SHO)
- Discharge A/C system, using approved refrigerant recovery/recycling equipment. Remove A/C compressor. Drain and measure oil from compressor.
- Remove pulley assembly. Using Spanner Wrench (T81P-19623-MH), remove shaft nut and lock washer. Using a steering wheel puller, remove clutch plate, shaft key and shim. Remove snap ring and pulley assembly, by hand. If necessary, use a 3-jaw puller to remove pulley assembly. Remove clutch coil wire from retaining brace on compressor. Remove snap ring and clutch coil. (Схема №1)
SANDEN SD-7H15 7-CYLINDER
Note. On Cherokee, Dakota, Durango, Ram Pickup and Wrangler, compressor clutch can be serviced in vehicle, without discharging A/C system.
Shaft seal is not serviceable. If excessive oil is present on pulley and plate friction surfaces or on compressor shaft nose area, replace compressor.