FLOOR JACK
Floor jack may be used under rear axle or front suspension lower control arms. Observe the following precautions
- NEVER use jack on any part of underbody.
- DO NOT raise entire vehicle at side rail with jack midway between front and rear wheels, or permanent body damage may result.
- DO NOT allow lifting plate fingers to contact axle cover plate when lifting at rear axle housing.
- If vehicle is equipped with a stabilizer bar, DO NOT lift at rear axle housing. (Scheme 9)
Scheme 9
BUMPER JACK
Bumper jack should only be used if supplied as original equipment with vehicle. If vehicle is not supplied with a bumper jack, DO NOT lift vehicle by the bumper at any time. Bumper jack should only be used to change flat tire.
FRAME CONTACT HOIST
Hoist adapters must contact vehicle in specified areas. (Scheme 10)and (Scheme 11). Adapters must be positioned to distribute load and support vehicle in a stable manner. DO NOT allow lift pads to contact exhaust system components.
| CAUTION | If removing rear axle, fuel tank, spare tire or liftgate using single-post hoist, anchor vehicle to hoist. Place jack stands under vehicle, or add weight on rear end of vehicle to prevent tipping when center of gravity changes. |
Scheme 10
Scheme 11
SUSPENSION CONTACT HOIST
Note. Always follow hoist manufacturer's instructions. DO NOT allow hoist or adapters to contact suspension, exhaust or steering components. Frame contact must be made. Use adapters if necessary. Lift vehicle as shown in illustrations. (Scheme 12)and (Scheme 13).
Hoist should contact lower control arms, or front crossmember and rear axle as shown in illustrations. (Scheme 9)
