Home ReviewsRefund
Home/Chevrolet/Avalanche/Chevrolet Avalanche I (2001-2006)/Repair manual/HVAC Systems - Automatic/Re-Calibrating Actuators
Contents Wiring diagrams Section: HVAC Systems - Automatic All sections

Re-Calibrating Actuators Chevrolet Avalanche I

HVAC Systems - Automatic ~164 words

Re-Calibrating Actuators

When replacing the HVAC control module it will be necessary to allow the HVAC control module to perform a re-calibration process. When installing the HVAC control module be sure to perform the following

Important: Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating. If interrupted improper HVAC performance will result.

  1. Place the ignition switch to the OFF position.
  2. Disconnect the scan tool.
  3. Install the HVAC control module.
  4. Re-connect all previously disconnected components.
  5. Start the vehicle.
  6. Wait 40 seconds for the HVAC control module to re-calibrate.
  7. Verify that no DTCs have set as current DTCs.

When replacing the motor assembly it will be necessary to allow the HVAC control module to perform a re-calibration process. When installing the motor assembly be sure to perform one of the following

Important: Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating. If interrupted improper HVAC performance will result.