- This procedure involves removing engine, transaxle, steering rack and engine frame as an assembly out bottom of vehicle. Disable Supplemental Inflatable Restraint (SIR) system. Discharge A/C system using approved refrigerant recovery/recycling equipment. Disconnect battery.
- Remove strut tower brace. Relieve fuel system pressure. See «FUEL PRESSURE RELEASE»(ref-54836-S13509505052001011700000) . Remove air cleaner inlet duct. Drain engine coolant. Remove radiator upper cover. Disconnect radiator hose at crossover and remove upper and lower radiator hoses from engine. Remove forward discriminating sensor from radiator support and set aside. Remove cooling fans. Disconnect transaxle cooler lines from radiator.
- Disconnect cruise control servo connections. Remove throttle and cruise control cables from throttle body. Remove shift cable from transaxle. Remove vacuum lines and fuel lines. Remove coolant reservoir. Disconnect positive battery cable from battery and body strap. Remove negative battery cable. Remove coolant hoses from front of engine.
- Working underneath dash, disconnect vacuum lines and engine wiring under instrument panel, wiring harness at PCM, and pull harness through cowl. Disconnect wiring and vacuum as needed to allow removal. Remove both hoses from power steering cooler.
- Raise and support vehicle. Remove both wheels. Separate both axles from steering knuckle. Remove back O2 sensor heat shield and connector. Disconnect exhaust hangers and remove catalytic converter. Disconnect steering coupler. Disconnect Fuel lines from transaxle.
- Remove battery lead from alternator. Remove A/C manifold from compressor and ABS modulator from frame. Position Support Table (J39580) under frame and lower vehicle onto table. Remove (6) frame-to-body bolts. Raise body off powertrain.
Home/Cadillac/DeVille Concours/Cadillac DeVille Concours (1994-1998)/Repair manual/Mechanical/Removal (preferred Method)
Contents
Section: Mechanical- Engine Identification
- Valve Clearance Adjustment
- Trouble Shooting
- Removal & Installation
- Fuel Pressure Release
- Cooling System Bleeding
- Removal (preferred Method)
- Installation (preferred Method)
- Removal (alternate Method)
- Installation (alternate Method)
- Removal & Installation (left)
- Removal & Installation (right)
- Cylinder Head
- Timing Chain Tensioner
- Removal (left)
- Installation (left)
- Removal (right)
- Installation (right)
- Setting Camshaft Timing
- Thermostat
- Valve Stem Oil Seal & Valve Spring
- Cylinder Head Gasket Surface
- Valve Springs
- Valve Stem Oil Seals
- Valve Guides
- Valve Seat
- Valves
- Valve Seat Correction Angles
- Fitting Pistons
- Piston Rings
- Rod Bearings
- Crankshaft & Main Bearings
- Thrust Bearing
- Cylinder Block Deck Surface
- Engine Lubrication System
- Crankcase Capacity
- Oil Pressure
- Removal & Disassembly
- Reassembly & Installation
- Torque Specifications
- General Specifications
- Camshaft Specifications
- Engine Valves & Valve Springs Specifications
- Cylinder Block Specifications
- Connecting Rods Specifications
- Cylinder Head Specifications
- Crankshaft, Main Bearings & Connecting Rod Bearings Specifications
- Pistons, Piston Pins & Piston Rings Specifications
- Valve Lifters Specifications
- Abbreviations
- Accessory Drive Belts
- Adjustments
- Airbag
- Anti-Lock/traction Control
- Application
- Automatic HVAC System
- Automatic Trans
- Axle Shafts
- Basic Trouble Shooting
- Body, Cab Control Systems
- Brakes
- Charging System
- Check Lists
- Computer Relearn
- Cooling Fan
- Cruise Control Systems
- Diagnostic Connector Locations
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- DTC Index
- Electrical
- Electrical Component Locations
- Electronic Suspension
- Emission Applications
- Engine
- Engine Performance
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Headlights
- Heated Glass/defoggers
- Identification
- Manual & Power Steering
- MAP Guidelines
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Mode 6
- Passive Restraints
- Procedures
- Removal & Installation
- Reset Procedures
- Restraints
- Rpo Codes
- Seats
- Sensor Range Charts
- Specifications
- Starter
- Steering
- Steering Column
- Steering Column Switches
- Sun Roof/t-Top/convertible Top
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Theory & Operation
- Traction Control Disable
- Transmission
- Wheel Alignment
- Windows
- Wiper/washer Systems
- Wiring Diagrams - Engine Performance