Home/Buick/LeSabre/Buick LeSabre VIII (2000-2005)/Repair manual/Lighting Systems/Removal Procedure

Contents

Wiring diagrams Section: Lighting Systems

FASTENER TIGHTENING SPECIFICATIONS

Test Description

SCAN TOOL DATA DEFINITIONS

Circuit Description

Conditions For Running DTC

Conditions For Setting DTC

Action Taken When DTC Sets

Conditions For Clearing DTC

Conditions For Clearing MIL/DTC

Conditions for Running the DTC

Conditions for Setting the DTC

Action Taken When the DTC Sets

Conditions for Clearing the MIL/DTC

Visual/Physical Inspection

Intermittent

Symptom List

CHECKING AFTERMARKET ACCESSORIES

Removal Procedure

Installation Procedure

HEADLAMP AIMING

Screen Method for Headlamp Aiming (Visual Aim)

Headlamp Aiming Procedure

Alternate Aiming Procedure

Exterior Lamps

Headlamps

Daytime Running Lamps (DRL)/Twilight Sentinel

Park, Tail & Marker Lamps

Remote Keyless Entry Exterior Lamp Illumination

Turn Signal/Cornering Lamps

Stop Lamps

Backup Lamps

High Beam

High Beam (With HUD)

Turn Signals

Turn Signals (With HUD)

TURN SIGNAL ON? - 20 (With DIC)

Battery Run Down Protection/Inadvertent Power

Interior Lamps

Courtesy/Illuminated Entry Lamps

Keyless Entry Interior Illumination

IP Compartment Lamp

Rear Compartment Lamp

Vanity Lamps

Interior Lamps Dimming

All sections

Removal Procedure Buick LeSabre VIII

Lighting Systems

Removal Procedure

Remove the left IP trim plate. Refer to «TRIM PLATE REPLACEMENT - IP ACCESSORY LEFT»(/buick/lesabre/viii-2000-2005/remont/gauges-instrument-panels/#instrument-panel-gauges-console) in Instrument Panel, Gages and Console.
Disconnect the electrical connectors (2, 3).
Remove the headlamp switch from the left IP trim plate. Remove the fastener (1). Tilt the headlamp switch (2) to remove.