61 31 996 Carrying out steering angle sensor adjustment
Note. Steering angle sensor adjustment must be carried out: after adjustment work on the front axle/steering after all mechanical work on the steering system after disconnection of battery after replacement/coding/programming of the following components: Fixture for switches of steering column/switch cluster/steering angle sensor Dynamic Stability Control (DSC) control unit
Connect vehicle to BMW diagnosis system.
Select and carry out steering angle sensor adjustment under Service functions.
Scheme 52
Scheme 53
61 31 204 Replacing switch combination for seat adjustment
Necessary preliminary tasks
- Remove «OUTER COVER»(ref-381274-S28565808022010122800000) on front seat
Disconnect plug connection (2).
Unlock retaining tabs (3) in direction of arrow and remove switch combination (1) from cover.
Installation
Retaining tabs (3) of cover and guide (4) of switch combination (1) must not be damaged.
Make sure switch combination (1) is correctly seated in retaining tabs (3).
Scheme 54
61 35 080 Removing and installing/replacing control unit/module for left or right seat adjustment
| IMPORTANT | Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) . |
Note. Move seat completely towards rear/top.
Unlock metal lug (1) towards front and remove control unit/module for seat adjustment (2) towards bottom.
Disconnect all associated plug connections.
Scheme 55
Installation
Make sure control unit/module for seat adjustment (1) is correctly seated in mounting (2).
Guides (3) and metal lug (4) must not be damaged.
Scheme 56
Replacement
Carry out vehicle programming/coding.