Steering and Wheel Alignment - Special Tools BMW Z4 E89

Gauge MW

Note. For vertical adjustment of the front axle

SI number

01 09 09 (532)

Consisting of

1 = 0496677 Gauge

Note. Left

2 = 0496678 Gauge

Note. Right

Scheme 1

Replaced by: 0492036

Note. (Test gauge) For measuring the drop arm - Replaced by 32 2 140.(0 492 036)

Consisting of

1 = 0492030 Spindle

Note. Discontinuation and replaced by 32 2 140.(0 492 036)

2 = 0492031 Shaped part

Note. (Shaped part) Discontinuation and replaced by 32 2 140.(0 492 036)

3 = 0492032 Bolt

Note. (Measuring bolt) Discontinuation and replaced by 32 2 140.(0 492 036)

Scheme 2

Open-end wrench insert MW

Note. (Open-end wrench insert) SW34 For releasing and tightening down track rod connection to steering gear (rack)

Storage Location

A84

01 01 04 (065)

Scheme 3

Plug Minimum set: Mechanical tools MW

Note. (Plugs (set)) 27-piece, 3x per size - For sealing off hydraulic lines for brakes, steering etc.

01 14 01 (766)

Scheme 4

Tool Minimum set: Mechanical tools MW

Note. (Adjustment tool) For adjusting the front camber.

B8

01 15 05 (200)

Consisting of

5 = 0493765 Spindle

Note. Replaced by 32 3 146 (0 495 355)

3 = 0494384 Ring

Note. (Support ring) Replaced by 32 3 145 (0 494 181)

Scheme 5

2 = 0493558 Ring

Note. (Support ring) Replaced by 32 3 145 (0 494 181)

2 = 0493559 Holder

Note. Replaced by 32 3 146 (0 495 355)

5 = 0494181 Washer

Note. For adjusting the camber on the front axle.

6 = 0495355 Spindle

7 = 0495356 Bolt

Note. (Knurled screw)

Note. (adjusting tool) For setting toe-in on rear axle - rear axle with KDS

B5

01 02 98 (302)

Scheme 6