Multi-Function Transmission Range (TR) Switch, installing Audi TT 8N рестайлинг

Multi-Function Transmission Range (TR) Switch, installing

Installation is performed in reverse order. When doing this note the following

1. Place Multi-Function Transmission Range (TR) Switch -F125- on selector shaft.
2. Hand-tighten Multi-Function Transmission Range (TR) Switch fastening screws - B -.
3. Install washers - 1 - , - 2 - and nut - 3 - on selector shaft.

Nut tightening torque: 7 Nm.

1. Secure nut by bending hooks on lock washer - 2 - up.

Note. If one or more hooks on lock washer are broken during bending, these must be replaced.

1. Adjust Multi-Function Transmission Range (TR) Switch -F125- --> «Multi-Function Transmission Range (TR) Switch -F125-, adjusting»(/audi/tt/8n-2003-2006/remont/blowers-superchargers-turbochargers/#18l-4-cyl-5v-turbo-generic-scan-tool-engine-codes-amu-bea-atc-awp__multi-function-transmission-range-tr-switch-f125)

1. Install lever/selector shaft - 1 -.

Nut - 3 - tightening torque: 12.5 Nm.

Note. Transmission must remain in "N" , shift back to "N" if necessary.

1. Connect connector - 5 - to Multi-Function Transmission Range (TR) Switch.
2. Press selector lever cable - 1 - onto lever/selector shaft - 6 -.

Note. Under some circumstances, you will have to switch the lever/selector shaft to the correct position in order to press selector lever cable on.

1. Do not kink selector lever cable.

1. Connect hose - 5 - to air filter housing.
2. Selector lever cable, checking adjustment --> «Selector lever cable, checking and adjusting»(/audi/tt/8n-2003-2006/remont/blowers-superchargers-turbochargers/#18l-4-cyl-5v-turbo-generic-scan-tool-engine-codes-amu-bea-atc-awp) .