SPRING MAT
Removing
| WARNING | Follow all safety precautions when working on pyrotechnic components. Refer to RESTRAINT SYSTEM COMPONENTS, SAFETY PRECAUTIONS AND TESTING PROCEDURES . Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin. |
Remove the front seat. Refer to FRONT SEAT .
Attach the front seat to the fixture for seat repair VAS 6136. Refer to INSTALLING FRONT SEAT ON VAS 6136 .
Remove backrest cover panel. Refer to BACKREST COVER .
Remove the headrests. Refer to HEADRESTS WITH LOCKING MECHANISM .
Remove cover with upholstery. Refer to BACKREST COVER AND UPHOLSTERY .
Disengage pull-springs -3- on backrest frame -1-.
Scheme 141
Note. The pull-springs -3- can also stay engaged in the backrest frame -1- and the spring mat -2- can be disengaged directly at the pull-springs.
Tip spring mat -3- forward.
Scheme 142
Remove spring mat -arrows- from backrest frame -1-.
2 - Pull-spring
Installation
Install in reverse order of removal. Note the following
| WARNING | Follow all safety precautions when working on pyrotechnic components. Refer to RESTRAINT SYSTEM COMPONENTS, SAFETY PRECAUTIONS AND TESTING PROCEDURES . Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin. |
Make sure the correct pull-spring (number of coils) is engaged at the location determined.
Note. Make sure the connectors are installed all the way in and are secure.
Switch on ignition.
| WARNING | Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery. |
Connect battery ground cable with ignition switched on. Refer to [For transmission(s) 02E] [For engine(s) CBRA, BPY, CETA, CCTA, CEPB, CDMA] Removal and Installation .
If Airbag Malfunction Indicator Lamp (MIL) -K75- indicates a fault after installation, DTC memory must be checked, deleted and checked again.