FRONT SEAT
Special tools and workshop equipment required
- Airbag adapter VAS 6281
Note. The removal and installation procedure describes a driver seat. The procedure for the front passenger seat is identical.
Removing
| WARNING | Follow all safety precautions when working on pyrotechnic components. Refer to RESTRAINT SYSTEM COMPONENTS, SAFETY PRECAUTIONS AND TESTING PROCEDURES . |
Bring seat into service position. Refer to BRINGING FRONT SEATS INTO SERVICE POSITION .
Switch off the ignition.
Disconnect battery ground cable. Refer to [For transmission(s) 02E] [For engine(s) CBRA, BPY, CETA, CCTA, CEPB, CDMA] Removal and Installation .
| WARNING | Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin. |
Disconnect the connectors on the connector station inside the floor panel. Refer to HARNESS CONNECTORS, DISCONNECTING AND CONNECTING
Connect Airbag Adapter VAS 6281. Refer to AIRBAG ADAPTER, CONNECTING .
Roadster Only
Scheme 124
Open retaining loop -1- by loosening push button -arrow-.
Remove seat belt -2- from retaining loop.
Procedure for all vehicles
Scheme 125
Remove front bolts -1- (quantity: 2).
3 - Rear console
4 - Front console
Press the seat forward/back adjustment handle and move the seat -2- as far forward as possible.
Remove rear bolts -1- (quantity: 2).
With help from a second mechanic, lift seat -2- out of vehicle.
Installation
Install in reverse order of removal. Note the following
| WARNING | Follow all safety precautions when working on pyrotechnic components. Refer to RESTRAINT SYSTEM COMPONENTS, SAFETY PRECAUTIONS AND TESTING PROCEDURES . Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin. |
Remove Airbag Adapter VAS 6281 only after installing seat. Refer to AIRBAG ADAPTER, CONNECTING .
Note. Make sure the connectors are installed all the way in and are secure.
Connect connector to connectors on connector station location in floor. Refer to HARNESS CONNECTORS, DISCONNECTING AND CONNECTING .
Switch on ignition.
| WARNING | Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery. |
Connect battery ground cable with ignition switched on. Refer to [For transmission(s) 02E] [For engine(s) CBRA, BPY, CETA, CCTA, CEPB, CDMA] Removal and Installation .
If Airbag Malfunction Indicator Lamp (MIL) -K75- indicates a fault after installation, DTC memory must be checked, deleted and checked again. .