ACCELERATOR PEDAL MODULE, VERSION 2
Special tools and workshop equipment required
- Release Tool T10238
Removing
Remove cover for steering column -arrows-.
Disconnect the connector -1- on the accelerator pedal module -3- by pulling the release -2- all the way up -arrow-.
Scheme 211
Pry off the cap -4- using a screwdriver.
Remove the bolt -5-.
Push the T10238 into the intended openings -arrow- as far as the stop, as shown, and remove the accelerator pedal module.
Installing
- Tightening specification, refer to «ACCELERATOR PEDAL MODULE OVERVIEW, VERSION 2»(/audi/tt/8j-2006-2010/remont/fuel-system/#fuel-supply-system-coupe) .
Install in reverse order, paying attention to the following
Connect the connector -2- on the accelerator pedal module -5-.
- The connector must engage audibly.
Push the accelerator pedal module onto the securing studs -6-.
Insert centering pin -7- into hole on the underbody.
Secure the accelerator pedal module with the bolt -3- and install the cap -4-.
Note. Ignore -1-.
Vehicles with Dual Clutch Transmission
Perform after the first kick-down adaptation in "Guided Functions" using the vehicle diagnostic tester.