ACCELERATOR PEDAL MODULE, VERSION 1
Special tools and workshop equipment required
- Release Tool T10238
Removing
Remove cover for steering column -arrows-.
Scheme 207
Disconnect electrical harness connector -2-, by pressing release button to the stop -arrow-.
Scheme 208
Where necessary, pull the wiring router -1- off from the accelerator pedal module.
Pry off the cover using a screwdriver.
Remove the bolt.
Push the T10238 into the intended openings -arrow- as far as the stop, as shown, and remove the accelerator pedal module.
Scheme 209
Installing
- Tightening specification, refer to «ACCELERATOR PEDAL MODULE OVERVIEW, VERSION 1»(/audi/tt/8j-2006-2010/remont/fuel-system/#fuel-supply-system-coupe) .
Install in reverse order, paying attention to the following
Connect the wiring router -1- and the electrical connector -2- to the accelerator pedal module -5-.
Scheme 210
- The connector must engage audibly.
Push the accelerator pedal module onto the securing studs -6-.
Insert centering pin -7- into hole on the underbody.
Secure the accelerator pedal module with the bolt -3- and install the cap -4-.
Vehicles with Dual Clutch Transmission
Perform after the first kick-down adaptation in "Guided Functions" using the vehicle diagnostic tester.