Speech Input Control Module J507 , removing and installing Audi S8 D3 facelift

Speech Input Control Module J507 , removing and installing

1. If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault-Finding" routine.

Use the Vehicle Diagnosis, Testing and Information System VAS 5051 to do so.

Removing

1. Remove Radio R --> «Radio R , removing and installing»(ref-289229-S38054691272008062700000) .

Scheme 174

1. Open cover - 2 - of Radio R and fold it downward - arrow -.
2. Carefully pull Speech Input Control Module J507 - 1 - out of Radio R in - direction of arrow -.

Installing

1. Install in reverse order.
2. Make sure that harness connector between Speech Input Control Module J507 and Radio R engages correctly in Radio R.

Perform the following function test

1. Switch on Radio R.
2. Press PTT button briefly on multi-function steering wheel.

A "ping" tone sounds, the speech dialog system is active.

1. Speak the command "Help"

Since the Radio R is active, the speech dialog system responds with "Radio commands are...".

Can be switched to other sources, depending on equipment

1. If a telephone is installed, say "Telephone".

The speech dialog system changes to Telephone mode.

1. Press the PPT button for approx. 1 second.

The speech dialog system responds with "Cancel" and is deactivated.