REMOVE THE IGNITION COILS FROM CYLINDER BANK 1
Remove air filter housing lower section. Refer to LOWER SECTION OF THE AIR FILTER .
Remove bolts -1- and -2-.
Scheme 2
Pull ignition coils approximately 30 mm out of spark plug shaft using Ignition Coil Puller T40039.
Scheme 3
Release electrical connectors and remove connectors simultaneously from ignition coils.
REMOVE THE IGNITION COILS FROM CYLINDER BANK 2
Remove the coolant expansion tank -arrow- and disconnect the connector on the Engine Coolant Level Warning Switch -F66- on the bottom of the expansion tank.
Scheme 4
Move the coolant reservoir to the side with hoses -1 and 3- connected.
Remove the bolts -2- and -3-.
Scheme 5
Pull ignition coils approximately 30 mm out of spark plug shaft using Ignition Coil Puller T40039.
Release electrical connectors and remove connectors simultaneously from ignition coils.