AMI EXTERNAL AUDIO SOURCE CONNECTION
Special tools and workshop equipment required
- Radio Removal Tool T10057
- Fiber optic plier repair set VAS 6223
- Protective cap for cable connector VAS 6223/9
The external audio source connection -R199- (AMI) is installed in the glove compartment.
Switch off all electrical consumers.
Remove the key.
Open glove compartment.
Insert the two clips of the T10057 into the release slits on the external audio source connection until they engage. Points on the grip eyelets of tool face outward.
Scheme 116
Pull external audio source connection out of mounting frame.
Disconnect all connectors from the external audio source connection.
Versions with MOST Bus
Connect the VAS 6223/9 -1- to the connector for the MOST Bus -2-.
All
Remove the T10057, push locking tabs on external audio source connection to do so.
Removing the Internal Control Unit
Remove the screw -2- on back side (2 Nm).
Scheme 117
Press the tabs -4- and -5- down then up and remove the control unit from the frame -1-.
Connect all harness connectors.
Slide the external audio source connection on the mounting frame until it engages.