Remove the noise insulation, to do this loosen the mounting parts -1, 2, 3-.
Scheme 9
Disconnect electrical connector -2-.
Scheme 10
Remove the bolt -1- and the Engine Speed (RPM) Sensor -G28
Contents
Section: Ignition System- Safety Precautions
- Ignition System
- Fastener Tightening Specifications
- Test Data
- Ignition Coils
- Remove the Ignition Coils from Cylinder Bank 1
- Remove the Ignition Coils from Cylinder Bank 2
- Installing
- Tightening Specifications
- Removing
- Camshaft Position Sensor
- Special Tools
- Abbreviations
- Airbag
- Anti-Lock/traction Control
- Automatic HVAC System
- Automatic Trans
- Axle Shafts
- Basic Trouble Shooting
- Brakes
- Cabin Air Filter
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Communication Devices
- Cooling Fan
- Cruise Control Systems
- Diagnostic Connector Locations
- Differentials & Drive Axles
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- DTC Index
- Electrical Component Locations
- Electronic Suspension
- Emission Applications
- Engine
- Engine Performance
- Exhaust
- Exterior Body Panels
- Exterior Lights
- Exterior/interior Trim
- Fuel System
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Identification
- Ignition System
- Lubrication System
- Manual & Power Steering
- Manual Trans
- MAP Guidelines
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Procedures
- Reset Procedures
- Seats
- Specifications
- Steering
- Sun Roof/t-Top/convertible Top
- Suspension Control Systems
- Suspension Front
- Suspension Rear
- Traction Control Disable
- Transmission
- Transmission Control Systems
- Wheel & Tire System
- Windows
- Wiper/washer Systems
- Wiring System (data Link Connectors, Pwr Dist., Grnd Dist.)