Home ReviewsRefund
Home/Audi/S4/Audi S4 B7 (2004-2008)/Repair manual/Electrical Equipment/Windshield Wiper/Washer Switch E22 , removing and installing
Contents Wiring diagrams Section: Electrical Equipment All sections

Windshield Wiper/Washer Switch E22 , removing and installing Audi S4 B7

Electrical Equipment 1 illustration ~132 words

Windshield Wiper/Washer Switch E22 , removing and installing

Removing

  1. Remove steering column switch module --> «Steering column switch module, removing and installing»(/audi/s4/b7-2004-2008/remont/cruise-control-systems/#electrical-equipment__steering-column-switch-module-removing-and) .
CAUTIONEnsure steering is in straight ahead and centered prior to removing spiral spring. Position of spiral spring must not be changed once removed.
  1. Carefully release clip fasteners - arrows - and remove spiral spring - 1 - from steering column switch module.
  1. Remove Steering Angle Sensor G85 - 1 - from Steering Column Electronic Systems Control Module J527 in direction of - arrow -.

Scheme 293

Scheme 293
Scheme 293
  1. Remove screws - 1 - and - 2 -.
  2. Remove Windshield Wiper/Washer Switch E22 - 3 - from steering column switch module - arrow -.

Installing

Further Install in reverse order of removal, noting the following

  1. Ensure all fasteners and electrical connectors are properly connected and locked into place.
  2. Install steering column switch module «Installing»(/audi/s4/b7-2004-2008/remont/cruise-control-systems/#electrical-equipment) .

Tightening torque

ComponentNm
Windshield Wiper/Washer Switch E22 to Steering Column Electronics Systems Control Module J5270.6