For the locations of the four camshaft position sensors. Refer to COMPONENT LOCATIONS OVERVIEW .
Removing
Disconnect electrical connector on the respective camshaft position sensor.
Remove lower air filter housing section to remove the Camshaft Position (CMP) sensor 3 -G300- on cylinder bank 1. Removing lower section of air filter housing. Refer to LOWER AIR FILTER HOUSING
Remove coolant reservoir to remove the CMP) sensor 4 -G301- on cylinder bank 2.
Disconnect electrical connector to the engine coolant level warning switch -F66- on the bottom of the coolant reservoir and lay the reservoir aside with the coolant hoses -1 and 2- and -3- attached.
Installing
Replace O-ring and lubricate it with clean engine oil.
Press camshaft position sensor in carefully by hand.
Tighten camshaft position sensor and connect electrical connector.
Further installation is in reverse order.
- Tightening specifications, refer to «IGNITION OVERVIEW»(ref-515429-S02812275052012120300000)