Removing and installing Audi A8 D3 facelift

Removing and installing

1. Remove plenum chamber cover on right.

Scheme 38

1. Disconnect harness connector - A - from sensor.
2. Rotate sensor 90° and pull sensor - B - upward out of mount.

Terminal assignment in connector - A

1 - B+ (terminal "15")

2 - Ground (terminal "31")

3 - Signal wire to Climatronic Control Module J255 , measured value is displayed in measured value block of Climatronic Control Module J255 (display group "022"). Square wave signal cannot be evaluated using workshop equipment.