Home/Audi/A8/Audi A8 D3 facelift 2 (2007-2010)/Repair manual/Communication/Drivers Volume Control Button E374 , removing and installing
Contents Wiring diagrams Section: Communication All sections

Drivers Volume Control Button E374 , removing and installing Audi A8 D3 facelift 2

Communication 3 illustrations ~203 words

Drivers Volume Control Button E374 , removing and installing

Removal and installation of Drivers Volume Control Button E374 and Front Passengers Volume Control Button E375 are identical.

Removal and installation of the short and long rear center console is distinguished by the additional removal of the cover of the short rear center console.

CAUTIONSwitch off all electrical components. Switch off ignition and remove ignition key.

Removing

Scheme 197

Scheme 197
  1. Unclip cover on buttons - arrows -.
  2. Unclip Drivers Volume Control Button E374 using a small screwdriver.
  3. Disconnect harness connectors on Drivers Volume Control Button E374.

Installing

  1. Install in reverse order.

Removal and installation of Multimedia Display Unit 1 Y22 and Multimedia Display Unit Y23 are identical.

CAUTIONSwitch off all electrical components. Switch off ignition and remove ignition key.

Removing

  1. Bring headrest to topmost position and tilt headrest forward.
  1. Pull cover of headrest - 2 - out of rail - 1 -.
  1. Remove bolt - arrow - (3 Nm) on inside of headrest.

Scheme 198

Scheme 198
  1. Carefully pry Multimedia Display Unit 1 Y22 out of headrest - arrow - using a suitable tool.

Scheme 199

Scheme 199
  1. Swivel Multimedia Display Unit 1 Y22 - 1 - out of headrest - 3 - and disconnect harness connector - 2 -.
  2. Remove Multimedia Display Unit 1 Y22 - 1 -.

Installing

  1. Install in reverse order.