Home/Audi/A8/Audi A8 D2 facelift (1999-2002)/Repair manual/On Board Diagnostic (OBD) - Radio, Navigation, Steering & Telematics/Adaptation (function 10)

Contents

Wiring diagrams Section: On Board Diagnostic (OBD) - Radio, Navigation, Steering & Telematics

Technical features of radio systems

Additional reference materials required

Safety precautions

Through m.y. 2001

From m.y. 2002

All vehicles

Control Module Versions, checking (function 01)

Output DTM, initiating

Requirements

End Output (function 06)

Code Control Module (function 07)

Coding procedure

Coding example: 00117

Coding example: 00637

Read Measuring Value Block, initiating

Display group 001 - through m.y. 2001

Adaptation (function 10)

Adaptation (function 10), initiating

Vehicle speed display, enable/disable

Long wave reception, enable/disable (where applicable)

Transport Mode, activate/deactivate

Equipment features

Display group 001

Adaptation, initiating

Tire circumference, adapting

Impulse number/wheel rotation (GALA), checking

Speaker connection, adapting

Country selection, adapting

Navigation IV - additional equipment features

Address word for Navigation: 37

Dynamic route guidance (where applicable), adapting

Technical features

Code control module, initiating

Coding example - control module Index "C": 00101

Telematics, technical features

Coding example: 0003333

Transport Mode, activating/deactivating

Example: Deactivate Transport Mode

Emergency (back-up) battery adaptation examples

Example: Switch off emergency (back-up) battery

Example: Switch on emergency (back-up) battery

From m.y. 2001

All sections

Adaptation (function 10) Audi A8 D2 facelift

On Board Diagnostic (OBD) - Radio, Navigation, Steering & Telematics

Adaptation (function 10)

Use this function on "Symphony" radios from m.y. 2002 to initiate and store the following changes

Adapt (enable/disable) vehicle speed display in radio. This feature is used primarily for Driving School vehicles
Transport Mode - activate/deactivate. The radio system is disabled (switched-off) when Transport Mode is activated. This is necessary to reduce battery drain when vehicles are transported over long distances or stored for longer periods of time.
Adapt (enable/disable) Long-wave reception (where applicable).

Individual functions are called up using the appropriate channel number from adaptation table. See ADAPTATION FUNCTIONS - RADIO .