Right engine mount, removing and installing Audi A6 C6 рестайлинг

Right engine mount, removing and installing

Special tools, testers and auxiliary items required

1. Engine support bridge 10 - 222 A

1. Engine Support Basic Set T40091

1. Engine Support Supplement Set T40093

Removing

Note. During installation, all cable ties must be re-installed at the same location.

1. Pull rear engine cover - arrows - off.

1. Remove rubber seal - 1 - and remove plenum chamber cover - 2 -.

1. Remove bolts - arrows -.
2. Remove air duct - 1 and 2 -.

1. Free up fuel line and line to EVAP canister on air filter housing.
2. Disconnect electrical harness connector - 1 - at Mass Air Flow (MAF) Sensor G70.
3. Remove air guide pipe from air filter housing by loosening hose clamps - 5 - and opening clips - arrows -.

Note. Ignore items - 2, 3, 4 -.

1. Open clips - arrows - and remove upper part of air filter housing.

1. Disconnect vacuum line - 1 -.
2. Remove pin from spreader clips - 4 -.
3. Remove lower part of air filter housing and, on the backside, separate electrical connection - 2 - at intake air switch-over valve N335.
4. Remove secondary air injection air guide hose - 3 - by pressing release buttons.

1. Secure Adapter 10 - 222 A/4 with connector T40091/3 and supports T40093/1 and T40093/2 to suspension strut towers.

1. Support for left and right side of vehicle is marked.

Scheme 456

1. Install additional Engine Support Bridge 10 - 222 A parts as shown in illustration. Position supports T40093/3 on long member notches.
2. Engage Hook 10 - 222 A/10 in left engine lifting eye.
3. Tension engine with spindle.
4. Remove right front wheel.

1. Remove sound insulation by loosening securing pieces - 1, 2, arrow -.

1. Remove bolts - 1 and 2 - for left and right stabilizer bar mount.
2. Slightly lower stabilizer bar.

1. Free up electrical wires on right engine mount plate.
2. Remove nut - 3 -.
3. Remove bolts - 1 and 2 - and remove right engine mount plate.

1. Disconnect electrical harness connector - 1 - at right engine mount.
2. Remove bolts - arrows - and remove engine support with engine mount.

1. Remove nut - arrow - and remove engine mount from engine support.

Installing

1. Tightening torques --> «Assembly mount, overview»(/audi/a6/c6-2008-2011/remont/cooling-fan/#42l-v8-4v-engine-mechanical-engine-codes-bvj) .

Installation is in reverse order of removal, note the following

Note. Replace bolts which have been tightened to torque. During installation, all cable ties must be re-installed at the same location.

1. Install stabilizer bar --> «40 - FRONT SUSPENSION»(/audi/a6/c6-2008-2011/remont/axle-shafts/#suspension-wheels-steering) .