Exhaust System, Checking for Leaks
- Start engine and let run at idle.
- Seal tailpipes with cloths or plug for the duration of the leak test.
- Check for leaks by listening at connection areas of cylinder head/exhaust manifold, exhaust manifold/front exhaust pipe etc.
- Repair leaks detected.
See also:
• 27 - STARTER, GENERATOR, CRUISE CONTROL
• 66 - EXTERIOR EQUIPMENT
• 00 TECHNICAL DATA
• 40 - FRONT SUSPENSION
• 87 - AIR CONDITIONING
• 24 - FUEL INJECTION SYSTEM
• 39 FINAL DRIVE, REAR DIFFERENTIAL
• 39 - FINAL DRIVE, DIFFERENTIAL
• 01 - MAINTENANCE
• Before Opening High Pressure Fuel Injection System
• Clean Working Conditions
• Contact Corrosion
• Lines, Routing and Securing
• Engine and Transmission, Separating
• Engine, Securing to Engine and Transmission Holder
• Engine, Installing
• Exhaust System, Installing
• Ribbed Belt, Removing and Installing
• Engine, Removing
• Engine and Automatic Transmission 09L, Separating
• Coolant Pump Ribbed Belt Pulley, Removing and Installing
• Power Steering Pump Ribbed Belt Pulley, Removing and Installing
• Ribbed Belt Side Sealing Flange with Crankshaft Seal, Replacing
• Coolant Pump, Removing and Installing
• Damper Unit, Removing and Installing
• Flywheel, Multitronic Transmission, Removing and Installing
• Drive Plate, Automatic Transmission 09L, Removing and Installing
• Centering washer for drive plate on automatic transmission 09L
• Camshaft Timing Chain, Component Overview
• Power Take-Off Drive Chain, from 04.06, Removing and Installing
• Balancing Shaft, Removing and Installing
• Crankshaft, Component Overview
• Crankshaft Dimensions
• Axial Clearance, Measuring
• Radial Clearance, Measuring
• Piston and Connecting Rod, Component Overview
• Piston and Cylinder Dimensions
• Connecting Rod, Checking Radial Clearance
• Oil spray jet for piston cooling
• Cylinder Head, Component Overview
• Left Cylinder Head Cover, Removing and Installing
• Right Cylinder Head Cover, Removing and Installing
• Brake Booster Vacuum Pump, Removing and Installing
• Front Coolant Line, Removing and Installing
• Camshafts, Checking Axial Clearance
• Valve Stem Seals, Cylinder Head Removed, Replacing
• Hydraulic Adjusting Elements, Checking
• Valves, Checking
• Valve Guides, Checking
• Oil Pan Sections, Oil Pump and Oil Cooler, Component Overview
• Oil Pan Lower Section, Removing and Installing
• Oil Pump, Removing and Installing
• Oil Pan Upper Section, Removing and Installing
• Oil Filter Housing, Component Overview
• Oil Pressure Switch, Removing and Installing
• Engine Oil Specifications
• Engine, with Multitronic Transmission, Removing and Installing
• Coolant Thermostat, Removing and Installing
• Thermostat, Checking
• Engine Coolant Temperature Sensor, Removing and Installing
• Left Coolant Pipes, Removing and Installing
• Fan Shroud, Removing and Installing
• Coolant Fan, Removing and Installing
• Center Muffler and Rear Muffler, Separating
• Tail Pipe, Replacing
• Left Exhaust Manifold, Removing and Installing
• Right Exhaust Manifold, Removing and Installing
• Exhaust System, Checking for Leaks
• Installed position of front double clamps
• Installed position of rear double clamps
• Individual left mounting components - vehicles with manual transmission and automatic transmission 09L