SUN SHADE
Removing
Remove D-pillar trim. Refer to D-PILLAR TRIM .
Remove the rear shelf. Refer to REAR SHELF .
Vehicles equipped with a subwoofer: remove the subwoofer in rear shelf -R157- Removal and Installation .
Vehicles equipped with an additional rear shelf mount: remove screw -2- and spacer -1-.
Note. Ignore -arrow-.
Remove the bolts -arrows- on the sun shade guide strip.
Scheme 93
Tilt the guide strip -3- in slightly and disengage both latches -2- and -4- by rotating slightly.
Scheme 94
Remove the guide strip from the connecting piece -1- on the sun shade.
Repeat the procedure on the opposite guide strip.
Disconnect the electrical connector -arrow- on the sun shade.
Scheme 95
Using a flat-head screwdriver, press the retaining tab -1- and pry out the luggage compartment light -2-.
Scheme 96
Note. The electrical connector -3- remains connected.
Remove the bolts -arrows-.
Scheme 97
Remove the sun shade carefully. Be careful with the rear window defroster electrical wires.
Installing
Scheme 98
Install in reverse order of removal. Note the following
If removed, install the rear of the rear shelf -2- on the sun shade -1- -arrows-, aligning both parts to each other.
Install the rear shelf and rear sun shade into the rear window frame and tighten.
Install the sun shade and rear shelf into the body.
Scheme 99
- The pins on the rear shelf -1- must fit into the mounts -arrows- under the rear window.
2 - Rear shelf trim
Tighten the sun shade bolts -arrows-.
Carefully install the guide strip -1- into the sunroof shade connector -arrow-.
Scheme 100
- The sun shade guide channel must run into the guide strip without the connecting piece being offset.
Clip the guide strip -3- at both retaining hooks -2- and -4- on the front and rear with the connecting piece -1-.
To ensure the retaining hooks -1- are seated securely, pull them forward until they engage completely using an offset screwdriver -arrow-.
Scheme 101
Vehicles equipped with an additional rear shelf mount: install the spacer (Scheme 23).