Home ReviewsRefund
Home/Audi/A4/Audi A4 B8 (2007-2012)/Repair manual/2.0l - Engine Assembly - Engine Code(s): Caeb (avant)/ENGINE, SUPPORT WITH ENGINE SUPPORT BRIDGE
Contents Wiring diagrams Section: 2.0l - Engine Assembly - Engine Code(s): Caeb (avant) All sections

ENGINE, SUPPORT WITH ENGINE SUPPORT BRIDGE Audi A4 B8

2.0l - Engine Assembly - Engine Code(s): Caeb (avant) 3 illustrations ~166 words

ENGINE, SUPPORT WITH ENGINE SUPPORT BRIDGE

Special tools and workshop equipment required

  1. Engine Support Bridge 10 - 222 A

Supporting

Remove the engine cover -arrows-.

Scheme 307

Scheme 307
Scheme 307

Install the 10 - 222 A with adapters 10 - 222 A /3 on the left and right strut towers, as shown in the illustration.

Scheme 308

Scheme 308
Scheme 308

Engage the spindles 10 - 222 A /11 to the engine lifting eyes.

Lightly pretension engine with spindles.

Scheme 309

Scheme 309: SUBFRAME MOUNT OVERVIEW
Scheme 309: SUBFRAME MOUNT OVERVIEW
  1. Not installed
  2. Bolt 20 Nm
  3. Retaining Plate For the engine mount If the engine mount is faulty, replace the retaining plate Check the retaining plate on the opposite side; replace if necessary
  4. Bracket For the hydraulic line
  5. Nut 9 Nm
  6. Bolt 40 Nm
  7. Engine Support
  8. Bolt 10 Nm
  9. Heat Shield
  10. Bolt Replace 90 Nm + 90° turn
  11. Engine Mount With the left electrohydraulic engine mount solenoid valve -N144- (left side only) Removing and installing, refer to «ENGINE MOUNT»(/audi/a4/b8-2007-2012/remont/mechanical/#20l-engine-assembly-engine-codes-caeb-avant__engine-mount) Replace in pairs only
  12. Subframe
  13. Bolt 55 Nm