Home ReviewsRefund
Home/Acura/TL/Acura TL III (2003-2006)/Repair manual/Vsa (vehicle Stability Assist) System/Steering Angle Sensor Replacement
Contents Wiring diagrams Section: Vsa (vehicle Stability Assist) System All sections

Steering Angle Sensor Replacement Acura TL III

Vsa (vehicle Stability Assist) System 1 illustration ~113 words

Steering Angle Sensor Replacement

Note. Do not damage or drop the combination switch as the steering angle sensor is sensitive to shock and vibration.

Scheme 66

Scheme 66: Steering Angle Sensor Replacement
Scheme 66: Steering Angle Sensor Replacement
  1. Remove the steering wheel (see «STEERING WHEEL REMOVAL»(/acura/tl/iii-2003-2006/remont/manual-power-steering/#power-steering-system__steering-wheel-removal) ).
  2. Remove the steering column covers and combination switch assembly (see step 10 on «STEERING COLUMN REMOVAL AND INSTALLATION»(/acura/tl/iii-2003-2006/remont/manual-power-steering/#power-steering-system__steering-column-removal-and-installation) ).
  3. Remove the combination light switch (A) and the wiper/washer switch (B).
  4. Replace the combination switch body complete (C).
  5. Install the combination switch in the reverse order of removal. NOTE: Do not remove the steering angle sensor from the combination switch body.
  6. Do the VSA sensor neutral position memorization (see «VSA SENSOR NEUTRAL POSITION MEMORIZATION»(/acura/tl/iii-2003-2006/remont/anti-locktraction-control/#vsa-vehicle-stability-assist-system__vsa-sensor-neutral-position-memorization) ).