Home ReviewsRefund
Home/Acura/RSX/Acura RSX I facelift (2004-2006)/Repair manual/Testing & Diagnostics/DTC P2227: BARO Sensor Circuit Range/Performance Problem (2…
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P2227: BARO Sensor Circuit Range/Performance Problem (2005-2006 models) Acura RSX I facelift

Testing & Diagnostics ~358 words

Note. If DTC P0107, P0108, P1128 and/or P1129 are stored at the same time as DTC P2227, troubleshoot those DTCs first, then recheck for DTC P2227.

  1. Turn the ignition switch ON (II), and wait 2 seconds.
  2. Check the BARO SENSOR in the DATA LIST with the HDS. Is about 101 kPa (29.9 in.Hg, 760 mmHg), or about 2.9 V at sea level indicated? YES - Go to step 3. NO - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM (see «HOW TO UPDATE THE ECM/PCM»(ref-218783-S21903648732006021000000) ), then recheck. If the symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM (see «ECM/PCM REPLACEMENT»(ref-218785-S00586955502006021000000) ).
  3. Clear the DTC with the HDS.
  4. Start the engine. Hold the engine speed at 3,000 RPM without load (in Park or neutral) until the radiator fan comes on, then let it idle.
  5. Test-drive under these conditions, then connect the HDS. Engine coolant temperature above 158°F (70°C) A/T in D position (M/T in 4th gear) Throttle position between 12 degrees and 20 degrees for 2 seconds
  6. Monitor the OBD STATUS for DTC P2227 in the DTCs MENU with the HDS. Does the screen indicate FAILED? YES - Go to step 7. NO - If the screen indicates PASSED, intermittent failure, system is OK at this time. If the screen indicates NOT COMPLETED, go to step 4 and recheck.
  7. Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM (see «HOW TO UPDATE THE ECM/PCM»(ref-218783-S21903648732006021000000) ).
  8. Reset the ECM/PCM with the HDS.
  9. Do the ECM/PCM idle learn procedure (see «ECM/PCM IDLE LEARN PROCEDURE»(ref-218787-S18900728242006021000000) ).
  10. Check for Temporary DTCs or DTCs with the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P2227 is indicated, check for poor connections or loose terminals at the ECM/PCM, then go to step 1 . If any other Temporary DTCs or DTCs are indicated, go to the indicated «DTC'S TROUBLESHOOTING»(ref-218785-S20313967292006021000000) . NO - If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM (see «ECM/PCM REPLACEMENT»(ref-218785-S00586955502006021000000) ).

More articles — Pgm-Fi System