Home ReviewsRefund
Home/Acura/RDX/Acura RDX I рестайлинг (2009-2012)/Repair manual/Fuses & Circuit Breakers/Under-Dash Fuse/relay Box
Contents Section: Fuses & Circuit Breakers All sections

Under-Dash Fuse/relay Box Acura RDX I рестайлинг

Fuses & Circuit Breakers 1 illustration ~325 words

Removal and Installation

Special Tools Required

Relay Puller 07AAC-000A2A1 or 07AAC-000A1A0

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing or servicing.

Scheme 2

Scheme 2: Removal
Scheme 2: Removal
  1. Do the battery terminal disconnection procedure (see «USING THE GR8 BATTERY DIAGNOSTIC STATION»(/acura/rdx/i-2009-2012/remont/body-electrical/#battery) ).
  2. Remove the driver's dashboard undercover (see «CENTER PANEL REMOVAL/INSTALLATION»(/acura/rdx/i-2009-2012/remont/gauges-instrument-panels/#dashboard__center-panel-removalinstallation) ).
  3. Disconnect the connectors from the fuse side of the under-dash fuse/relay box (A).
  4. Remove the mounting bolts, and pull the fuse/relay box away from the body.
  5. Disconnect the connectors from the back side of the under-dash fuse/relay box, then remove the under-dash fuse/relay box.
  6. Carefully remove the relays by using the relay puller. NOTE: Do not use pliers. Pliers will damage the relays, which could cause the engine to stall or not start.

Installation

Note. The MICU which is part of the under-dash fuse/relay box is a component of the immobilizer system. Because of this construction, the MICU must be registered when the under-dash fuse/relay box is replaced, or the vehicle will not start.

  1. Install the relays and connect the connectors to the under-dash fuse/relay box, then install the under-dash fuse/relay box in the reverse order of removal.
  2. Install the removed parts in the reverse order of removal.
  3. Do the battery terminal reconnection procedure (see «RECONNECTION»(/acura/rdx/i-2009-2012/remont/body-electrical/#battery__reconnection) ).
  4. If the under-dash fuse/relay box is replaced, go to step 5. If the original under-dash fuse/relay box is installed, go to step 10 .
  5. Connect the HDS to the data link connector (DLC).
  6. Turn the ignition switch to ON (II).
  7. Select the IMMOBI from SYSTEM SELECTION MENU, then select IMMOBILIZER SET UP.
  8. Select the REPLACE MPCS/MICU/IMOES, then select the suitable menu from the HDS indications.
  9. After registration, confirm that the vehicle will start.
  10. Confirm that all systems work properly.

More articles — Electrical