DTC P0111: IAT Sensor Circuit Range/Performance Problem Acura MDX II facelift

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).

1. Check for poor connections or loose terminals at ECT sensor 1, ECT sensor 2, and the MAF sensor/I AT sensor. Are the connections and terminals OK? YES -Go to step 2. NO -Repair the connections or terminals, then go to step 16 .
2. Remove the MAF sensor/IAT sensor (see «MAF SENSOR/IAT SENSOR REPLACEMENT»(ref-510432-S23376976682012102300000) ).
3. Allow the MAF sensor/IAT sensor to cool to the ambient temperature.
4. Note the ambient temperature.
5. Set the HDS to the PGM-FI DATA LIST for IAT SENSOR.
6. Connect the MAF sensor/IAT sensor to its 5P connector, but do not install it.
7. Turn the ignition switch to ON (II).
8. Quickly note the value of the IAT SENSOR quickly in the DATA LIST with the HDS.
9. Compare the value of the IAT SENSOR to the ambient temperature. Does the value of the IAT SENSOR differ 5.4 °F (3 °C) or more from the ambient temperature? YES -Go to step 14 . NO -Go to step 10.
10. Disconnect the MAF sensor/IAT sensor from the 5P connector.
11. Using a heat gun, blow hot air on the MAF sensor/IAT sensor for a few seconds. Do not apply the heat longer than a few seconds or you will damage the sensor.
12. Connect the MAF sensor/IAT sensor to its 5P connector, but do not install it.
13. Check the IAT SENSOR in the DATA LIST with the HDS. Does the IAT SENSOR change 77 °F (43 °C) or more? YES -Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the MAF sensor/IAT sensor and the PCM. NO -Go to step 14.
14. Turn the ignition switch to LOCK (0).
15. Replace the MAF sensor/IAT sensor (see «MAF SENSOR/IAT SENSOR REPLACEMENT»(ref-510432-S23376976682012102300000) ).
16. Turn the ignition switch to ON (II).
17. Reset the PCM with the HDS.
18. Do the PCM idle learn procedure (see «PCM IDLE LEARN PROCEDURE»(ref-510456-S37172493852012102300000) ).
19. Check for Pending or Confirmed DTCs with the HDS. Is DTC P0111 indicated? YES -Check for poor connections or loose terminals at the MAF sensor/IAT sensor and the PCM, then go to step 1 . NO -Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated «DTC'S TROUBLESHOOTING»(ref-510432-S17608727802012102300000) .