Home ReviewsRefund
Home/Acura/MDX/Acura MDX II рестайлинг (2010-2013)/Repair manual/Rear Differential/SH-AWD® Control Unit Initialization
Contents Section: Rear Differential All sections

SH-AWD® Control Unit Initialization Acura MDX II рестайлинг

Rear Differential 1 illustration ~108 words

SH-AWD® Control Unit Initialization

Whenever the SH-AWD control unit is replaced, it must be initialized.

Scheme 10

Scheme 10: SH-AWD® Control Unit Initialization
Scheme 10: SH-AWD® Control Unit Initialization
  1. With the ignition switch in LOCK (0), connect the HDS to the data link connector (DLC) (A) behind the driver's dashboard lower cover.
  2. Turn the ignition switch to ON (II).
  3. Make sure the HDS communicates with the vehicle and the SH-AWD control unit. If it does not, go to the DLC circuit troubleshooting (see «DLC CIRCUIT TROUBLESHOOTING»(/acura/mdx/ii-2010-2013/remont/testing-diagnostics/#pgm-fi-system__dlc-circuit-troubleshooting) ).
  4. From the mode menu, select SH-AWD, select MISCELLANEOUS TEST, then select INITIALIZATION with the HDS, and follow the screen prompts. NOTE: See the HDS help menu for specific instructions.