Sunvisor Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program; call 888-424-6857
Note. Take care not to scratch the headliner. Be careful not to damage the dashboard and other interior trim. Use the appropriate tool from the KTC trim tool set to avoid damage when removing components. When using a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Scheme 107
Scheme 108
Scheme 109
Scheme 110
- Using a trim tool, release the tabs (A) of the sunvisor cap (B) from the bracket (C).
- Remove the sunvisor (A). Remove the screws. Remove the sunvisor from the body and holder (B). Disconnect the vanity mirror light connector (C).
- Using a flat-tip screwdriver, push the hook (A), and turn the holder (B) 90°, then pull it out.
- If the side curtain airbag has deployed (see «COMPONENT REPLACEMENT/INSPECTION AFTER DEPLOYMENT»(/acura/mdx/ii-2006-2010/remont/airbag/#srs-supplemental-restraint-system__component-replacementinspection-after-deployment) ), replace the sunvisor with a new one.
- If the side curtain airbag has not deployed, to prevent the side curtain airbags from deploying improperly and possibly causing injury, inspect removed sunvisor and replace it if it has any cracks or damage: Any cracks in the sunvisor stay base (A) Any bends or cracks in the sunvisor stay shaft (B) Any cracks in the sunvisor base (C) Any cracks in the vanity mirror base (D)
- Install the sunvisor in the reverse order of removal, and make sure the vanity mirror light connector is plugged in properly.