Rear Electronic Module (REM) & Upper Electronics Module (Uem) Diagnostic Trouble Codes (Xc): Adjustments Volvo XC70 I рестайлинг

Calibrating the component

Note. If the vehicle is equipped with Four-C, calibration must be carried out via suspension module (SUM).

Calibrate the position sensor for the Bi-Xenon lamps.

1. Someone must sit in the driver, s seat during calibration. The person must weigh at least 75 kg. Ensure that the vehicle is unladen and is on a flat surface.
2. Ignition on
3. Click on the VCT2000 symbol
4. Calibrate the position sensor.

1. Continue Refer to «Verification»(ref-431020-S24987119092011101900000)

Note. If the vehicle is equipped with Four-C, calibration must be carried out via suspension module (SUM).

Calibrate the position sensor for the Bi-Xenon lamps.

1. Someone must sit in the driver's seat during calibration. The person must weigh at least 75 kg. Ensure that the car is unladen and is on a flat surface
2. Ignition on
3. Click on the VCT2000 symbol
4. Calibrate the position sensor.

1. Continue Refer to «Verification»(ref-431020-S11653863362011101900000)

Note. If the vehicle is equipped with Four-C, calibration must be carried out via suspension module (SUM).

Check that the position sensor for the Bi-Xenon lamps is correctly installed.

Someone must sit in the driver's seat during calibration. The person must weigh at least 75 kg. Ensure that the vehicle is unladen and is on a flat surface.

Calibrate the position sensor for the Bi-Xenon lamps again.

1. Ignition on
2. Click on the VCT2000 symbol
3. Calibrate the position sensor.

Other information

1. See «Replacing position sensors for Bi-Xenon lamps»(ref-431006-S11040000732011101900000)

1. Continue Refer to «Verification»(ref-431020-S37713127832011101900000)

Note. If the vehicle is equipped with Four-C, calibration must be carried out via suspension module (SUM).

Check that the position sensor for the Bi-Xenon lamps is correctly installed.

Someone must sit in the driver's seat during calibration. The person must weigh at least 75 kg. Ensure that the vehicle is unladen and is on a flat surface.

Calibrate the position sensor for the Bi-Xenon lamps again.

1. Ignition on
2. Click on the VCT2000 symbol
3. Calibrate the position sensor.

Other information

1. See «Replacing position sensors for Bi-Xenon lamps»(ref-431006-S11040000732011101900000)

1. Continue Refer to «Verification»(ref-431020-S08451260072011101900000)

See also:
• Signal specification
• Contents
• Checking wiring and terminals
• Parking assistance module (PAM), replacing