FLOOR JACK OR HOIST
Information is not available from manufacturer
CAMBER MEASUREMENT
- Fender panel edge dimension is used to determine camber. Dimension is measured vertically above wheel center between fender panel edge and lower edge of wheel trim. (Scheme 4)
- Read off camber angle for correct rim type against fender edge measurement obtained. Reading depends on type of wheel rim on vehicle. For example, if vehicle has a 15" aluminum rim and fender edge measurement of 23 5/16" (592 mm), camber angle should be -0.7 degrees (+/-.5 degrees). Measured camber angle on vehicle should be between -0.2 and -1.2 degrees.
