Damper motor module (DMM), recirculation, replacing (version 2) Volvo V70 II facelift

Damper motor module (DMM), recirculation, replacing (version 2)

The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Scheme 113

Remove

1. the glove compartment. See «Glove compartment, replacing»(ref-406929-S07996031032011070100000)
2. the switch HINT: Use a small electrician's screwdriver to pry up the switch by the lock. Depress the switch at the rear edge. Pull straight out.
3. the 2 x screws
4. the control module.

Check the functionality of the control module mechanism (1). Check that the arms for the dampers (2) are secure.

Install

1. the control module in position. Adjust the shaft journal in relation to the mechanism (1) so that it goes in
2. the 2 screws. Tighten alternately
3. the switch. Ensure that it is correctly positioned
4. the glove compartment. See «Glove compartment, replacing»(ref-406929-S07996031032011070100000)

Note. Identify the damper motor module (DMM) for recirculation. See VIDA vehicle communication.