REMOVING LEFT ENGINE PAD
Remove the left engine pad. See ENGINE SUPPORT INSULATOR LEFT .
Scheme 34
Remove
- the 3 screws
- the bracket.
Scheme 35
Detach the shift cable from the arm using see 9997077 .
Press out the spring pin with see 9997221 . Use the long pressure pin.
Remove the lever.
Scheme 36
Remove the plate from see 9992709 .
Fit see 9997219 on the sledge hammer.
Carefully tap down the puller in the bottom of the shift rail.
Screw in the puller screw.
Remove the seal.
| CAUTION | If the shaft is rusty, first clean away any rust. Clean around the flange, not up and down. Use sand paper 951 1024 or a very fine emery cloth to clean the shaft. |
Clean around the shaft with isopropylalcohol and blow it clean with compressed air.
Note. For tightening torques, see TIGHTENING TORQUE .
Scheme 37
Install a new seal using see 9997220 .